Blog

Discover our latest articles and blogs

In Process Inspection: 3 Modes for Short Run CNC Shops
October 15, 2026

In Process Inspection: 3 Modes for Short Run CNC Shops

Learn how small CNC shops inspect parts during production, pick among three modes, set samples, record results, and connect checks to MES and ERP work orders.

Chip Evacuation Starts at Coolant: 3 Checks Before Changing Tools
October 14, 2026

Chip Evacuation Starts at Coolant: 3 Checks Before Changing Tools

Check coolant flow, nozzle aim, tool geometry, and feeds to diagnose chip evacuation problems. Find safe shop fixes, from through coolant to conveyors.

Tool Deflection: Machinists’ Checks for the 0.0005 Inch Finish Target
October 13, 2026

Tool Deflection: Machinists’ Checks for the 0.0005 Inch Finish Target

Learn how machinists estimate tool deflection, verify shop setups, and use finish and roughing limits to decide whether to adjust a cut or outsource.

Built Up Edge: Low Speeds, Rough Finish, and Shop Floor Fixes
October 12, 2026

Built Up Edge: Low Speeds, Rough Finish, and Shop Floor Fixes

Learn how built up edge forms, why low cutting speeds can roughen parts and wear tools, and which shop floor checks and adjustments help control it.

Thin Wall Machining for Prototype Shops: Feed Rate Shifts Above 20:1
October 11, 2026

Thin Wall Machining for Prototype Shops: Feed Rate Shifts Above 20:1

Thin wall machining for prototypes needs layered toolpaths, firm support, and controlled feeds. See why feed rates change above 20:1 and what to send your...

Ra vs Rz for Engineers: 4 Shop Floor Choices That Shift Readings
October 10, 2026

Ra vs Rz for Engineers: 4 Shop Floor Choices That Shift Readings

Learn when engineers should specify Ra or Rz, why conversion is unreliable, and how standards and measurement settings affect part acceptance.

Machinists: 4 Calibration Steps for On Machine Probing
October 9, 2026

Machinists: 4 Calibration Steps for On Machine Probing

Shop-floor guide for machinists: standards-backed calibration, NX CAM probing tips, and a 4-step validation checklist to catch errors before they scrap parts.

NIST Backed Perpendicularity Callouts for Engineers and Machinists
October 8, 2026

NIST Backed Perpendicularity Callouts for Engineers and Machinists

Engineer-first, shop-tested guidance to specify perpendicularity you can measure. Learn NIST-backed uncertainty rules, inspection steps, and spec-ready...

Engineers: Specify ASTM A967 for Stainless Passivation, Avoid Rework
October 7, 2026

Engineers: Specify ASTM A967 for Stainless Passivation, Avoid Rework

Engineer first guide linking ASTM/AMS/PRC specs to shop controls. Use citric or nitric, electropolish when appropriate, and test passivation.